This Page

 

 

We have stumbled on the article relating to How to Troubleshoot and Repair an Electric Water Heater down the page on the web and think it made good sense to share it with you here.

Many modern-day homes take advantage of an electric hot water heater for their heating unit, because of its convenience and also ease of use. Nevertheless, similar to any other electric home appliances, problems might occur with its usage, suddenly. It can be really irritating to wake up to a cool shower rather than a warm one or having your bath with water that isn't warm sufficient or perhaps as well warm. Whatever the situation may be, hot water heater problems can be rather nerve-racking. The good news is, we've made a checklist of possible remedies to your water heater concerns. There are a number of aspects that could create a lot of these troubles, it could be a problem with the power supply, the electrical heating element, or the thermostat. Prior to doing anything, ensure you switch off the main power supply for security. Whatever the problem is, getting it taken care of should not position way too much of an issue if you comply with these steps:

 

Inspect Your Power Supply:

As standard as this may seem, it is really necessary. Without appropriate power, your hot water heater will not work. So the first thing to do when your water suddenly stops working is to validate that it isn't a power problem. Check if the fuse is burnt out or the breaker tripped. If the circuit breaker is the problem, just transform it on and off once more. Replace any damaged or worn-out fuse. Check the device with power after these adjustments to see if it's now working.

 

Check the Heating Element in the Water Heater:

If it's not a power issue, after that attempt looking into your burner if it is still working. Test each of your heating elements to be sure the problem isn't with any of them. If any of them is malfunctioning, change that component and afterwards examine whether the warm water is back on.

 

Examine Your Thermostat:

If your hot water heater still isn't functioning or the water appearing isn't warm enough, you may need to inspect the temperature settings on your upper thermostat. Guarantee the circuit breaker is switched off before doing anything. Open the access panel and press the red button for temperature reset above the thermostat. This should aid warm the water. Transform the breaker back on as well as inspect if the issue has been fixed.

 

Call An Expert:

If after replacing all faulty parts and resetting your temperature level, the hot water heater still isn't working, you may need to get in touch with a professional plumber for an expert viewpoint. The issue with your heating unit could be that the hot and cold taps have been switched or it may be undersized for the amount of warm water required in your house. Whatever the instance might be, an expert plumber would certainly assist resolve the issue.

 

Final thought

Water heater problems are not always significant. Most of them result from small problems like a blown fuse or worn-out heating element. Changing the damaged components must work. However, if you are still unable to address the trouble, give a call to your nearby plumber to find to get it repaired.

 

8 possible reasons why you have no Hot Water

 

Along with streaming Netflix and having light flood a room when we flick a switch, having hot water flow from our taps and showerheads whenever we want is an oft-overlooked modern miracle of homeownership. That's why, when that flow goes cold, it can be shocking — and not just in a "Wow, that's freezing" kind of way while you're in the shower.

 

Water Leak

 

Before hot water reaches your taps and showerheads, it needs to spend some time in your water heater. This appliance, which can be either gas- or electric-powered, takes the cold water that enters your home from your well or utility company and cooks it until it gets hot. It's akin to an electric tea kettle.

Obviously, if your water heater is leaking, it will never fill with water so it won't have anything to warm. To see if this is the case, simply examine the area around the water heater to see if it is wet. If so, you'll likely need to replace the unit, but you can also call in a pro for a second opinion and to see if it is fixable. Sometimes leaks can happen around fixtures on the water heater, and if so, the solution might be as simple as replacing them.

 

Gas Heater: Gas Leak

 

If your hot water is fueled by natural gas and there is a leak in the supply line or where the line enters the tank, the appliance won't have the power it needs to heat up your water. The result is not only inconvenient, but it can be extremely dangerous as well. If you smell gas when you investigate your water heater, call your gas utility company immediately and report it as an emergency. It might also be prudent to leave your home until a repair person from the company arrives. Your utility company will usually fix any kind of gas leak. However, in terms of getting your water heater working again, you'll need to relight the pilot and wait a while to see if it is functioning properly. You can call in a water heater specialist or plumber to help with this.

 

Gas Heater: Pilot Light Problems

 

There are two other issues with gas-powered water heaters that can lead to a loss of hot water. The first is a pilot light that's blown out. The pilot light is the source of a constant flame inside your water heater. When the heater determines the need to heat up the water it is holding, it will open a valve that will cause gas to flow over the pilot light and cause it to ignite. To see if your pilot light is functioning, there is usually a small window in the front of the water heater. If you can't see a flame, remove the access panel and see if that helps you locate it. If there is still no flame, you'll need to relight it in accordance with the manufacturer's instructions.

Your pilot light should burn with a bright blue flame. If not, make sure there are no drafts affecting it, which could keep it from functioning properly. If the flame looks yellow, it might be a sign of the presence of carbon monoxide, which spells trouble and needs to be looked at right away by a technician.

 

Gas Heater: Faulty Thermocouple

 

The second reason why a gas-powered water heater might fail is a faulty thermocouple. This is a small probe that should sit in the pilot light flame. Its purpose is to stop the flow of gas if it senses that the pilot light is out. Sometimes, these probes get knocked off track, so make sure it is directly in the flame. They can also get a buildup on them that prevents their function, so try cleaning yours off with some steel wool or fine-grit sandpaper. If your pilot light won't stay lit and you've tried these steps to fix the thermocouple, it is likely faulty and needs to be replaced. Call a technician.

 

Electric Heater: Breaker Blues

 

Electric water heaters don't have pilot lights, because there is no gas to burn in order to heat up the water. Instead, they do their magic through the use of (naturally) electricity. But that's not to say things can't go wrong with them. If your electric water heater isn't working properly, there's a good chance that a breaker was tripped that supplies the appliance power. Check your breaker box and flip any breakers that have switched to the off position back on. If it trips again, then there might be a fault in the water heater, and you'll want to call in a pro to have a look.

 

Electric Heater: Reaching The Limit

 

If the breaker is fine, check to see if the high-temperature limit has switched off on the water heater itself. To do so, first turn off the breaker to the unit. Then remove the service panel and press the red button you'll find there. This is the limit switch, and resetting it could solve your problem. To check, replace the panel, turn the breaker back on and listen to see if the water heater is functioning again.

 

Electric Heater: Heating Element

 

If these steps don't fix the issue, then you might have a failed heating element, which will need to be replaced. Unless you are comfortable with such repairs, calling in a technician might make the most sense.

https://www.homeserve.com/en-us/blog/home-improvement/no-water-heater/

 

Hopefully you liked our piece about What Would Cause My Electric Water Heater to Stop Working?. Many thanks for taking the time to browse our blog. Sharing is caring. Helping others is fun. Kudos for your time. Visit us again soon.

Book An Appointment